August Entry: the Under Halls

[Gamerprinter]

NK, I used a grid to create these tiles. In some cases, I offer very narrow passages only as wide as a doorway. If a PC can fit through a door, then can fit down a passage that is less than 5 feet wide (approx. 3 feet), though I try to mimize use of such narrow passages. Most all other passages were created using 1 inch grid on an 8 x 10 layout.

"Narrow" meaning you can fit through, but you can't fight in melee combat.

In some cases, where the outer wall is less than 5 feet wide, most of the inner halls are 5 feet wide but may not be centered with the grid. Is this really a problem?

After I post these and the last three, probably later tonight, I will begin gridding these tiles and try to post as many as possible tomorrow.

If I have to tweak, where I got it wrong, well, then I'll do just that. But as far as I can tell, it should work.

NEXT FIVE TILES
4 Waterworks Tiles (sounds better than drainage tiles)
1st of the Cavern Tiles.

Almost finished with the design part...

EDIT: in retrospect, I think I'm going to create a 9" x 11" grid, centered over the 8x10 tile, dropped under the walls, removed over non-traversable areas, then the outer half inch all around the cut away to the tile borders - it will still be an 8 x 10 grid, just with half a grid under the outer walls. I'm not sure how this would be handled in a VT app, but that's how I plan to do the printed grid dungeon tiles.

GP