Gotcha, simple. Thanks, man.
Gotcha, simple. Thanks, man.
If the radiance of a thousand suns was to burst at once into the sky, that would be like the splendor of the Mighty One...I am become Death, the Shatterer of worlds.
-J. Robert Oppenheimer (father of the atom bomb) alluding to The Bhagavad Gita (Chapter 11, Verse 32)
My Maps ~ My Brushes ~ My Tutorials ~ My Challenge Maps
Step 5: The Mountain layer and the heightfield
Hide all the layers except the heightfield layer and select it. (See Screen shot 2)
Choose the select by colour tool. Set the feather edges slider to about 20 and the threshold slider to 50.(See Screen shot 3)
Choose the lightest point on the layer and select it. An area smaller than the higher ground selection should be highlighted.(See Screen Shot 4)
Unhide the hidden layers and add another one called "Mountain" on the top.
Select Bucket fill and add a light grey texture. Once again the lighter the texture the more effectively it will pick up the bump map. (See Screen shot 5)
Torq
The internet! It\'ll never catch on.
Software Used: Terranoise, Wilbur, Terragen, The Gimp, Inkscape, Mojoworld
Step 5 Continued.
Select the mountain layer. Apply a bump map. (Filters>>Map>>Bump Map). Apply the heightfield as the bump map to the mountain layer. As can be seen from Screenshot 1 the elevation has been set to about 5 and the elevation has been increased to 5. Hit OK and apply the bump map. The result should look something like Screenshot 2.
Torq
The internet! It\'ll never catch on.
Software Used: Terranoise, Wilbur, Terragen, The Gimp, Inkscape, Mojoworld
Step 6: What about a bit of water
I know this was supposed to be a mountain tutorial but lets add some water.
Add a new light blue layer below the land layers. Hide the other layers and select the bottom heightfield layer. (See Screenshot 1)
Choose the select by colour tool (make sure that the feather edges box is unchecked) and set the threshold slide to about 60.(See Screenshot 2).
Now click on the black areas of the rivers in the heighfield. This will select all the lowlying areas and the largest of the river channels.(See Screenshot 3).
Unhide all the layers and select the (greenish) ground layer (Screenshot 4) and delete the selected areas (Edit>>Clear). Repeat this after you have selected the high ground layer. The result should look something like screenshot 5.
The internet! It\'ll never catch on.
Software Used: Terranoise, Wilbur, Terragen, The Gimp, Inkscape, Mojoworld
Here is the same map after the colours have been tweaked, a dark blue border has been added and a forest included.
If you do use this tutorial please post your results in this thread, together with any questions you may have about the method.
Torq
The internet! It\'ll never catch on.
Software Used: Terranoise, Wilbur, Terragen, The Gimp, Inkscape, Mojoworld
The thing that I've been struggling most with is trying to get rid of the hard beveling on the rivers that Wilbur does. I'm pretty sure it's in the settings/values/numbers used but I haven't been able to find something softer.
If the radiance of a thousand suns was to burst at once into the sky, that would be like the splendor of the Mighty One...I am become Death, the Shatterer of worlds.
-J. Robert Oppenheimer (father of the atom bomb) alluding to The Bhagavad Gita (Chapter 11, Verse 32)
My Maps ~ My Brushes ~ My Tutorials ~ My Challenge Maps
Posting Permissions
Reply With Quote